Welcome to the Cave Diver's Forum.
+ Reply to Thread
Results 1 to 3 of 3

Thread: Mako manual

  1. #1
    Member
    Join Date
    Feb 2007
    Location
    NW Alabama
    Posts
    698

    Default Mako manual

    Does anyone have a pdf repair manual for a Mako scooter?
    I have the regular one but need to know how to disassemble the motor/clutch section.
    A pdf, link, or a PM describing the procedure would be greatly appreciated.

    If cave diving were Star Wars, who would be Yoda?

  2. #2
    Member
    Join Date
    Dec 2006
    Location
    Gainesville, FL
    Posts
    88

    Default

    Here is a link I found a while back. There are some good links

    http://www.scubaboard.com/forums/div...-mako-dpv.html


  3. #3
    Member
    Join Date
    Feb 2007
    Location
    NW Alabama
    Posts
    698

    Default

    To remove motor,

    1 Remove battery
    2 Remove screws that attach mid section to motor section
    3 Lift off mid section, remove 2 motor wires and 2 switch wires while noting locations
    4 Remove screw in adjusting cap and remove cap, watch for detent ball and spring, ball will attempt to escape
    5 Remove 3 screws holding propeller hub and remove prop blades and outer hub, the plastic shaft in the center will come with it
    6 Remove screw holding clutch washers and remove washers. Note orientation of washers! Take off inner hub and plate behind it
    7 Remove drive pin from shaft, pull off washer and spring, then carefully pry off seal assembly
    8 Stand scooter on shroud and apply pressure to motor downward, will pop right out, o-rings and silicone are holding it in

    That stay at the Holiday Inn Express did wonders last night!

    If cave diving were Star Wars, who would be Yoda?


 

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts