Help needed with light part

[bob1577]

Hoping someone out there can help me. I bought a light off Steve Gamble few years back and still works good. Only problem is i broke the cover glass.
Its an older type light with the bulb inside a kinda small test tube. The tube is about 1.5 inches in diameter and about 5 inches long.( not at home so have not exact measurements )

Just wondering can these still be bought somewhere on the net or a shop. As cannot find anything similar on places i have looked.

Thanks for you help

Irish BOB

[FW]

Try asking Steve first: http://www.gamblescuba.com/


If he can't help you, measure the old tube, and I may have some still around. The inside diameter is what is critical.

[tj]

You sure its 5" ? How about 2.5 to 3 " ? I have one that size.. or two...

tj

Hoping someone out there can help me. I bought a light off Steve Gamble few years back and still works good. Only problem is i broke the cover glass.
Its an older type light with the bulb inside a kinda small test tube. The tube is about 1.5 inches in diameter and about 5 inches long.( not at home so have not exact measurements )

Just wondering can these still be bought somewhere on the net or a shop. As cannot find anything similar on places i have looked.

Thanks for you help

Irish BOB

[FW]

Hmmm, how old is the light? HID, or halogen? The really old lights had long tubes, and the newer ones have shorter tubes.

[wdrennaker]

If you are near my shop stop in. I have the 3 different globes in stock.

Bill

[Attchoum]

I think Sartek still have those tube in the part to sell on they web site.

etienne

[bob1577]

Ok I was slightly off with my measurements. Its actually 7 cm ( 2 3/4 inches ) long to the cone tip and 2 cm ( 1 3/4 in ) wide inside diameter. Anyone have a spare one lying around or know where i can get one.

Thanks for the help you guys

[Scott]

came across this today while looking for something else.
http://northeastscubasupply.com/stor...s/cat_311.html