WTB PST E7 100 cu ft cylinder

[wlamm]

need to make a set of doubles.

Edit: this was in response to the above when he asked for a HP95, before he edited it to HP100.

No such animal. Pressed Steel's 95 was a low pressure cylinder.

Another thing: if you indeed determine your cylinder is a low pressure, another one may or may not make a suitable match. Cylinders from different batches varied in height by as much as 3/4 of an inch. So you need to take precise measurements before you double them up.

Russell

[wlamm]

Thanks for the information. Yeah I thought the cylinder was a 95 but it is a HP 100. Bill

[wlamm]

I found one. Thanks