DIN upgrades

[JE]

I received the two DIN adapters for my Micras & was hoping someone could direct me to a technician who could assist me with installing these to my USD regulators-? Anyone-? I would be happy to provide the dive vehicle, Pizza & refreshments afterwards-! {Bribery Intended}

JE

Did you forget I'm a technician? I could probably step you through it over the phone, assuming you have the proper tools.

Russell

[BobK]

I could probably do it also. I should have the correct tools, unless there is a special socket required for your yoke nut. Russell, do you know the torque specs for these ?

Fifteen foot pounds, plus or minus two.

Russell

[JE]

I appreciate your offer of assistence. I think I have the job done, within a couple of ft pounds. Don't believe I overtorqued them either, but it wouldn't hurt to have them ck'd. What a difference in simplicity it makes . I really like them. I'm streamlining my gear setup as well, & hopefully next time I get to dive with either or both of you, I'll be in much better form.
Thanks again.
:)
Jack


ps: When I have my new Primary, & single stage set up, I'll make some plans to get with you both.

pss: Pizza, beer, & dive still on me-! Just say when & where-!

[jammer]

Fifteen foot pounds, plus or minus two.

Russell

That sounds a little on the high side is it foot pounds? or Inch pounds?

It's in foot pounds. That's actually lower than Scubapro, which uses 266 inch pounds. Fifteen foot pounds is 180 inch pounds.

Russell

[jammer]

Ok Russell I trust you you are the tech I was just curious